D-LINK

NETWORK ADAPTER (P/N D8611)

NIC Type      D-Link Network, Proprietary
Transfer Rate 1Mbps
Data Bus      8-bit ISA
Topology      Linear bus
Wiring Type   Unshielded twisted pair
Boot ROM      Available

[Image]

                               NODE ADDRESS

  Node   SW1/1    SW1/2   SW1/3   SW1/4    SW1/5   SW1/6    SW1/7   SW1/8

   0      On       On      On      On       On      On       On      On

   1      On       On      On      On       On      On       On      Off

   2      On       On      On      On       On      On      Off      On

   3      On       On      On      On       On      On      Off      Off

   4      On       On      On      On       On      Off      On      On

  251     Off     Off      Off     Off     Off      On      Off      Off

  252     Off     Off      Off     Off     Off      Off      On      On

  253     Off     Off      Off     Off     Off      Off      On      Off

  254     Off     Off      Off     Off     Off      Off     Off      On

  255      -       -        -       -       -        -       -        -

  Notes: Node address 0 is used for messaging between nodes and must not
  be used.

  A total of 255 node address settings are available. The switches are a
  binary representation of the decimal node addresses. Switch 1 is the
  Least Significant Bit and switch 8 is the Most Significant Bit. The
  switches have the following decimal values: switch 1=128, 2=64, 3=32,
  4=16, 5=8, 6=4, 7=2, 8=1. Turn off the switches and add the values of
  the off switches to obtain the correct node address.

  (On=0, Off=1)

                             INTERRUPT REQUEST

      IRQ           JP1A           JP1B           JP1C          SW2/1

  »      2           N/A            N/A            N/A           Off

         3         Closed          Open           Open            On

         4          Open          Closed          Open            On

         5          Open           Open          Closed           On

  Note:If the card is installed in a PC/AT compatible the IRQ should be
  IRQ5, IRQ3, or IRQ4. You should try the interrupts in that order.

                            ONBOARD TERMINATOR

           Setting                    JP2A                   JP2B

  »          Disabled                 Open                  Closed

             Enabled                 Closed                  Open

  Note:If the card is on either end of a linear bus network segment, the
  onboard terminator may be

                             BOOT ROM ADDRESS

       Address              Software           JP3A             JP3B
                           Parameter

  »   CC000 - CFFFFh          HC               Open            Closed

      DC000 - DFFFFh          HD              Closed            Open

       Note:The software parameter is used in the DEVICE= statement in
       the CONFIG.SYS file (e.g. DEVICE = D-LINK.DRV /HC).

                                DMA CHANNEL

                Channel                               SW2/2

  »                 DMA1                               Off

                    DMA3                                On

                             I/O BASE ADDRESS

          Address                   SW2/3                   SW2/4

              240h                   Off                     On

              260h                   Off                     Off

              340h                    On                     On

  »           360h                    On                     Off

                                 BOOT ROM

                 Setting                               SW2/6

  »               Disabled                             Open

                   Enabled                            Closed

  FACTORY CONFIGURED SETTINGS

     Switch         Setting

     SW2/5           Unused