ADVANCED INTERLINK CORPORATION

AICEther-8/10BT (No Boot ROM)

NIC Type      Ethernet
Transfer Rate 10Mbps
Data Bus      8-bit ISA
Topology      Star
Wiring Type   Unshielded twisted pair
Boot ROM      Not available

[Image]

                          SEGMENT LENGTH

     Maximum Segment Length                     JP1

           100 meters                         Closed

           300 meters                          Open

  Note:Segment length is the distance from the card to the hub.

                             I/O BASE ADDRESS

          Address                   JP2D                    JP2E

             200h                  Closed                  Closed

             210h                  Closed                   Open

  »          300h                   Open                   Closed

             310h                   Open                    Open

                             INTERRUPT REQUEST

       IRQ               JP2F               JP2G               JP2H

           2            Closed              Open               Open

  »        3             Open              Closed              Open

           5             Open               Open              Closed

                           RECEIVE WIRE POLARITY

                   Mode                                  SW1

  »                 Normal                               On

                   Inverted                              Off

       Note:If the diagnostic LEDs indicate that the receive wires'
       polarities are reversed (LED1 Off, Hub LED On) you can

                              TX/RX CROSSOVER

                   Mode                                  SW2

  »                  Normal                              On

                   Crossover                             Off

       Note:If the diagnostic LEDs indicate that the transmit & receive
       wires are reversed (LED1 Off, Hub LED Off) you can correct the
       problem by using the crossover option.

  FACTORY CONFIGURED SETTINGS

     Jumper         Setting

      JP2A           Unused

      JP2B           Unused

      JP2C           Unused

      JP4            Unused

                             DIAGNOSTIC LED(S)

       LED1             Hub LED                    Condition

        On                On              Network connection is good

        Off               Off         Transmit/Receive crossover at card

        On                Off          Receive polarity reversed at hub

        Off               On           Receive polarity reversed at card

  Note:The Hub LED is located on the hub, not on the card.