ADVANCED INTERLINK CORPORATION

AICETHER-8/10BT (BOOT ROM VERSION)

NIC Type      Ethernet
Transfer Rate 10Mbps
Data Bus      8-bit ISA
Topology      Star
Wiring Type   Unshielded twisted pair
Boot ROM      Available

[Image]

                             INTERRUPT REQUEST

   IRQ       JP9A       JP9B      JP9C       JP9D       JP9E       JP9F

      2      Open       Open      Open       Open       Open      Closed

  »   3      Open       Open      Open       Open      Closed      Open

      4     Closed      Open      Open       Open       Open       Open

      5      Open       Open      Open      Closed      Open       Open

      6      Open      Closed     Open       Open       Open       Open

      7      Open       Open     Closed      Open       Open       Open

                             I/O BASE ADDRESS

          Address                   JP9G                    JP9H

             200h                  Closed                  Closed

             210h                   Open                   Closed

  »          300h                  Closed                   Open

             310h                   Open                    Open

                                 BOOT ROM

                 Setting                               JP13

  »               Disabled                             Open

                   Enabled                            Closed

  Note:Location of the boot ROM may vary on different revisions of this
  card.

        BOOT ROM ADDRESS

  Address    JP14A      JP14B

   C800h     Closed    Closed

   CC00h     Closed     Open

   D000h      Open     Closed

   D400h      Open      Open

                           RECEIVE WIRE POLARITY

                   Mode                                  SW1

  »                 Normal                               On

                   Inverted                              Off

  Note:If the diagnostic LEDs indicate that the receive wires' polarities
  are reversed at the card (LED1 Off, Hub LED

                              TX/RX CROSSOVER

                   Mode                                  SW2

  »                  Normal                              On

                   Crossover                             Off

       Note:If the diagnostic LEDs indicate that the transmit & receive
       wires are reversed (LED1 Off, Hub LED Off) you can correct the
       problem by using the crossover option.

                             DIAGNOSTIC LED(S)

       LED1             Hub LED                    Condition

        On                On              Network connection is good

        Off               Off         Transmit/Receive crossover at card

        On                Off          Receive polarity reversed at hub

        Off               On           Receive polarity reversed at card

  Note:The Hub LED is located on the hub, not on the card.