ANCO TECHNOLOGY, INC.

E5002

NIC Type      Ethernet
Transfer Rate 10Mbps
Data Bus      16-bit ISA
Topology      Star
Wiring Type   Unshielded twisted pair

              AUI transceiver via DB-15 port
Boot ROM      Available

[Image]

                             INTERRUPT REQUEST

   IRQ      JP1A     JP1B      JP1C     JP1D     JP1E     JP1F     JP1G

      2/9   Closed   Open      Open     Open     Open     Open     Open

  »   3     Open     Closed    Open     Open     Open     Open     Open

      6     Open     Open     Closed    Open     Open     Open     Open

      6     Open     Open      Open    Closed    Open     Open     Open

      7     Open     Open      Open     Open    Closed    Open     Open

      11    Open     Open      Open     Open     Open    Closed    Open

      12    Open     Open      Open     Open     Open     Open    Closed

                            LINK INTEGRITY TEST

                Setting                                JP31

  »                Enabled                       Pins 1 & 2 Closed

                  Disabled                       Pins 2 & 3 Closed

  Note:Link Integrity is only used with 10Base-T wiring. When using an
  AUI transciever, the test should be disabled.

                                CABLE TYPE

                     Type                                 SW1/2

  »      Shielded/Unshielded twisted pair                  On

          AUI transceiver via DB-15 port                   Off

                             I/O BASE ADDRESS

           Address                    SW1/3                  SW1/4

  »          300-31Fh                   On                    On

             320-33Fh                  Off                    On

             340-35Fh                   On                    Off

             360-37Fh                  Off                    Of

                     BOOT ROM ADDRESS

  Address      SW1/5       SW1/6      SW1/7       SW1/8

  Disabled      Off         Off        Off         Off

   C4000h       On          On          On         Off

   C8000h       Off         On          On         Off

   CC000h       On          Off         On         Off

   D0000h       Off         Off         On         Off

   D4000h       On          On         Off         Off

   D8000h       Off         On         Off         Off

   DC000h       On          Off        Off         Off

                             DIAGNOSTIC LED(S)

    LED       Link Integrity      Status               Condition

    LED1         Enabled            On            Twisted pair network
                                                    connection good

    LED1         Enabled           Off            Twisted pair network
                                                   connection broken

    LED1         Disabled           On           Data is being received
                                                         power

    LED1         Disabled          Off         Data is not being received
                                                         power

  Note:The condition designated by LED1 depends on the setting of the
  link integrity switch SW1/1.