DANPEX CORPORATION (ADI SYSTEMS, INC.)

Aquila AQ-NE/2CX (MCA)

NIC Type      Ethernet
Transfer Rate 10Mbps
Data Bus      16-bit MCA
Topology      Linear bus
Wiring Type   RG-58A/U 50ohm coaxial

              AUI Transceiver via DB-15 port
Boot ROM      Available

[Image]

                                CABLE TYPE

             Type                       JP2A              JP2B - JP2I

  »    RG-58A/U 50ohm coaxial    Pins 1 & 2 Closed     Pins 2 & 3 Closed

         AUI transceiver via     Pins 1 & 2 Closed     Pins 1 & 2 Closed
             DB-15 port

                            ONBOARD TERMINATOR

                  Mode                                 JP3

  »                Enable                       Pins 1 & 2 Closed

                  Disable                       Pins 2 & 3 Closed

  Note:If the card is on either end of a linear bus network segment, the
  onboard terminator may be used instead

                             DIAGNOSTIC LED(S)

     LED         Color        Status                Condition

    LED1         Green         Off               Normal operation

    LED2        Yellow       Blinking       Data is being transmitted

    LED2        Yellow         Off        Data is not being transmitted

    LED3          Red           On        Collision detected on network

    LED3          Red          Off           No collisions detected on
                                                     network

    LED4         Green       Blinking         Data is being received

    LED4         Green         Off          Data is not being received