ANCO TECHNOLOGY, INC.

E5001

NIC Type      Ethernet
Transfer Rate 10Mbps
Data Bus      8-bit ISA
Topology      Star
Wiring Type   Unshielded twisted pair

              AUI transceiver via DB-15 port
Boot ROM      Available

[Image]

                             INTERRUPT REQUEST

     IRQ         JP1A        JP1B         JP1C        JP1D        JP1E

       2/9      Closed       Open         Open        Open        Open

  »     3        Open       Closed        Open        Open        Open

        6        Open        Open        Closed       Open        Open

        6        Open        Open         Open       Closed       Open

        7        Open        Open         Open        Open       Closed

                                CABLE TYPE

                   Type                                 SW1/1

  »         Unshielded twisted pair                       On

         AUI transceiver via DB-15 port                  Off

                            LINK INTEGRITY TEST

                Setting                                JP31

  »                Enabled                       Pins 1 & 2 Closed

                  Disabled                       Pins 2 & 3 Closed

  Note:Link Integrity is only used with 10Base-T wiring. When using an
  AUI transciever, the test should be disabled.

                             I/O BASE ADDRESS

           Address                    SW1/3                  SW1/4

  »          300-31Fh                   On                    On

             320-33Fh                  Off                    On

             340-35Fh                   On                    Off

             360-37Fh                  Off                    Off

                     BOOT ROM ADDRESS

  Address      SW1/5       SW1/6      SW1/7       SW1/8

  Disabled      Off         Off        Off         Off

   C4000h       On          On          On         Off

   C8000h       Off         On          On         Off

   CC000h       On          Off         On         Off

   D0000h       Off         Off         On         Off

   D4000h       On          On         Off         Off

   D8000h       Off         On         Off         Off

   DC000h       On          Off        Off         Off

                             DIAGNOSTIC LED(S)

    LED       Link Integrity      Status               Condition

    LED1          Enabled           On            Twisted pair network
                                                    connection good

    LED1          Enabled           Off           Twisted pair network
                                                   connection broken

    LED1         Disabled           On           Data is being received
                                                         power

    LED1         Disabled           Off        Data is not being received
                                                         power

  Note:The condition shown by LED1 depends on the setting of the link
  integrity test switch SW1/2. (see above)