Self Test for Pioneer DRM-600, DRM-602X, DRM-604X, DRM-624X & DRM-1804X  


Self Test for Pioneer CD-ROM DRIVES
 
1. Eject all disc cartgidges from changer.
 
2. Power down the unit and disconnect the SCSI cable.
 
3. Set SCSI ID to 0.
 
4. Set selector switches on back of drive to the following:
 
        DRM-600         Set SW 6 & 8 Up, all others Down
        DRM-602X        Set SW 3 & 4 Up, all others Down
        DRM-604X        Set SW 5 & 6 Up, all others Down
        DRM-1804X       Set SW 5 & 6 Up, all others Down
 
Note: This test will NOT work if there are less than six CD's in the
cartridge.  Make sure that they are loaded with label side facing down.
Also, the drive must be terminated.
 
5. Place the cartridge(s) in the unit and power on.
 
If the unit operates properly:
It will select one disc after another and:
        On the DRM-600 the Audio light will flash
        On the DRM-602X the Magazine Locked light will flash
        On the DRM-604X the 4X light will flash
        On the DRM-1804X the Audio light will flash
 
For the DRM-624X, follow steps 1 through 3.
 
        DRM-624X        Set SW 2, 3 & 4 Up, all others Down
 
Place the cartridge in the DRM-624X, hold down the "Eject" and on
the power.  This must be done "simultaneously"
 
        On the DRM-624X the busy light will flash
 
When these lights flash, the unit is indicating that it has successfully
read each disc's Table of Contents.  After the sixth disc, the
cartridge will eject.
 
If the unit is not functioning properly:
 
If the drive fails to perform Self Test successfully, check discs
for scratches and dirt.  Swap discs to see if problem follows disc.  If
so, the disc is not readable.  If problem persists, re-check setup.
 
Should a failure occur contact Pioneer Electronic Service at:
 
                800-872-4159
 
They will refer you to the closest Authorized Service Center