LONGSHINE MICROSYSTEM, INC. LCS-6624/B (UM-6624-B00) Card Type Hard drive controller card Hard Drives supported Two IDE (AT) drives Floppy drives supported Two 360KB, 720KB, 1.2MB, or 1.44MB drives Data Bus 16-bit ISA Card Size Half-length, half-height card [Image] CONNECTIONS Function Location Function Location 34-pin cable connector J1 9-pin serial port 1 - J5 - floppy drive external 40-pin primary IDE(AT) J2 25-pin parallel port - J6 connector external 16-pin game port J3 2-pin connector - JP1 drive active LED 10-pin serial port 2 - J4 internal USER CONFIGURABLE SETTINGS Function Label Position » Hardware configuration setting JP3 Pins 2 & 3 closed Software configuration setting JP3 Pins 1 & 2 closed » Factory configured - do not alter JP5 Closed » Floppy drive interface enabled JP6 Closed Floppy drive interface disabled JP6 Open PARALLEL PORT ADDRESS SELECTION Setting JP10 JP11 LPT1 (378h) Pins 2 & 3 closed Pins 1 & 2 closed » LPT2 (278h) Pins 1 & 2 closed Pins 1 & 2 closed LPT3 (3BCh) Pins 1 & 2 closed Pins 2 & 3 closed Disabled Pins 2 & 3 closed Pins 2 & 3 closed SERIAL PORT 1 & 2 ADDRESS SELECTION Setting JP7 JP8 JP9 Serial 1 COM1 / Pins 1 & 2 Pins 1 & 2 Pins 1 & 2 serial 2 COM2 closed closed closed Serial 1 COM1 / Pins 1 & 2 Pins 2 & 3 Pins 1 & 2 serial 2 disabled closed closed closed Serial 1 COM2 / Pins 1 & 2 Pins 1 & 2 Pins 2 & 3 serial 2 COM1 closed closed closed Serial 1 disabled / Pins 2 & 3 Pins 1 & 2 Pins 2 & 3 serial 2 COM1 closed closed closed Serial 1 disabled / Pins 2 & 3 Pins 1 & 2 Pins 1 & 2 serial 2 COM2 closed closed closed Serial 1 COM2 / Pins 1 & 2 Pins 2 & 3 Pins 2 & 3 serial 2 disabled closed closed closed Serial 1 disabled / Pins 2 & 3 Pins 2 & 3 N/A serial 2 disabled closed closed IDE INTERFACE ENABLE Setting JP2 JP4 Enable Closed Closed Disabled Open Open