NEC TECHNOLOGIES, INC.

T-130B (CD-XT003)

Card Type               Hard drive controller
Hard Drives supported   Up to 7 SCSI devices
Floppy drives supported None
Data Bus                8-bit ISA
Card Size               Half-length, full-height

[Image]

                                CONNECTIONS

         Function             Label            Function            Label

  50-pin SCSI connector -      J2      25-pin SCSI connector -      P1
  internal                             external

  Drive active LED             JP4

                        USER CONFIGURABLE SETTINGS

                Function                      Label          Position

  »   Zero wait state enabled                  JP2            Closed

      Zero wait state disabled                 JP2             Open

  »   Boot ROM enabled                        SW1/6             Off

      Boot ROM disabled                       SW1/6             On

  »   Factory configured - do not alter       SW1/7             Off

  »   Factory configured - do not alter       SW1/8             Off

                        BOOT ROM ADDRESS SELECTION

      Setting             SW1/3             SW1/4             SW1/5

       CA000h              Off               Off                On

       CE000h              Off               On                Off

       DA000h               On               Off               Off

       DE000h               On               Off                On

            Note:If no EPROM chip installed in the boot ROM socket, the
            above switches should be in the "off" position.

                           I/O ADDRESS SELECTION

          Setting                   SW1/1                   SW1/2

              240h                    On                     On

              250h                    On                     Off

              340h                   Off                     On

  »           350h                   Off                     Off

                            INTERRUPT SELECTION

    Setting           JP3/pins 1 & 2        JP3/pins 3 &    JP3/pins 5 &
                                                 4               6

      IRQ3                Closed                Open            Open

      IRQ5                 Open                Closed           Open

      IRQ7                 Open                 Open           Closed

    Disabled        Pins 2 & 4 closed