UNIDENTIFIED

IDE-9 CARD

Data Bus                16-bit ISA
Card Size               Third height, half length
Hard Drives Supported   Two IDE(AT) devices
Floppy Drives Supported Two 360KB, 720KB, 1.2MB, or 1.44MB drives

[Image]

                                CONNECTIONS

         Function             Label           Function            Label

  34-pin cable connector -    CON1      2-pin drive active         LED
  floppy drive                          LED

  40-pin primary IDE(AT)      CON2
  connector

                        USER CONFIGURABLE SETTINGS

                  Setting                      Label         Position

  IRQ14 enabled                                 JP1         Pins 2 & 3
                                                              closed

  IRQ14 disabled                                JP1         Pins 1 & 2
                                                              closed

  IDE IOCHRDY signal enabled                    JP2         Pins 2 & 3
                                                              closed

  IDE IOCHRDY signal disabled                   JP2         Pins 1 & 2
                                                              closed

  Factory configured - do not alter             JP3         Pins 1 & 2
                                                              closed

  Floppy interface uses primary address         JP4         Pins 1 & 2
                                                              closed

  Floppy interface uses secondary address       JP4         Pins 2 & 3
                                                              closed

  Floppy interface enabled                      JP5         Pins 1 & 2
                                                              closed

  Floppy interface disabled                     JP5         Pins 2 & 3
                                                              closed

  IDE(AT) interface enabled                     JP6         Pins 1 & 2
                                                              closed

  IDE(AT) interface disabled                    JP6         Pins 2 & 3
                                                              closed

  IDE(AT) interface uses primary address        JP7         Pins 1 & 2
                                                              closed

  IDE(AT) interface uses secondary address      JP7         Pins 2 & 3
                                                              closed