UNITED MICROELECTRONICS CORPORATION

FSIO-UC3 (V1.1)

Data Bus                16-bit ISA
Card Size               Half-length, half-height card
Hard Drives supported   Two IDE (AT) drives
Floppy drives supported Two 360KB, 720KB, 1.2MB, or 1.44MB drives

[Image]

                                CONNECTIONS

        Function          Location           Function           Location

  40-pin IDE(AT)             CN1      10-pin serial port 2 -      CN5
  connector                           internal

  34-pin cable connector     CN2      25-pin parallel port -      CN6
  - floppy drive                      external

  16-pin game port           CN3      4-pin connector -            J2
                                      drive active LED

  10-pin serial port 1 -     CN4
  internal

  Note: The location of J2 is unidentified.

                        USER CONFIGURABLE SETTINGS

                 Function                    Label         Position

      IOCHRDY signal disabled                 J1            Closed

      IOCHRDY signal enabled                  J1             Open

      Serial port 2 enabled                   JP2      Pins 1 & 2 closed

      Serial port 2 disabled                  JP2      Pins 2 & 3 closed

      Game port enabled                       JP3      Pins 1 & 2 closed

      Game port disabled                      JP3      Pins 2 & 3 closed

  »   Factory configured - do not alter       JP4        Unidentified

      Parallel port I/O address is            JP5      Pins 1 & 2 closed
      378-37Fh

      Parallel port I/O address is            JP5      Pins 2 & 3 closed
      278-27Fh

      Serial port 1 enabled                   JP6      Pins 1 & 2 closed

      Serial port 1 disabled                  JP6      Pins 2 & 3 closed

      Floppy drive interface enabled          JP7      Pins 1 & 2 closed

      Floppy drive interface disabled         JP7      Pins 2 & 3 closed

  »   Factory configured - do not alter       JP8        Unidentified

      IDE(AT) interface enabled               JP9      Pins 1 & 2 closed

      IDE(AT) interface disabled              JP9      Pins 2 & 3 closed

  »   Factory configured - do not alter      JP10        Unidentified