ACCULOGIC, INC. SIDE-3/PLUS (REV.2) Data bus: 16-bit ISA Size: Half-length, full-height card Hard drive supported: Two IDE(AT) drives Floppy drives supported: Two 360KB, 720KB, 1.2MB, 1.44MB, or 2.88MB drives [Image] CONNECTIONS Function Location 4-pin connector - drive active LED J1 40-pin primary IDE(AT) connector J2 34-pin cable connector - floppy drive J3 Optional drive power connector J4 USER CONFIGURABLE SETTINGS Function Location Setting » Floppy drive interface enabled JP6 Open Floppy drive interface disabled JP6 Closed » IDE(AT) interface enabled JP7 Open IDE(AT) interface disabled JP7 Closed » Single speed floppy drives JP8 Open supported Dual speed floppy drives JP8 Closed supported » Floppy drive precompensation is JP9 Open 125 ns Floppy drive precompensation is JP9 Closed 187 ns » IOCHRDY signal disabled JP10 Open IOCHRDY signal enabled JP10 Closed USER CONFIGURABLE SETTINGS (CONTINUED) Function Location Setting » On-board BIOS ROM enabled JP11 Open On-board BIOS ROM disabled JP11 Closed » Primary floppy is any type JP14 Open other than 2.88 MB Primary floppy is 2.88 MB JP14 Closed drive » Secondary floppy is any type JP15 Open other than 2.88 MB Secondary floppy is 2.88 MB JP15 Closed drive INTERRUPT TIMING SELECTION Timing JP1 JP2 » Normal Closed Open Delayed until ACTIVE-signal is Open Closed removed BIOS ADDRESS SELECTION Address JP12 JP13 » C8000-CBFFFh Open Open CC000-CFFFFh Open Closed D8000-DBFFFh Closed Open DC000-DFFFFh Closed Closed