UNIDENTIFIED

HAF-M

  Data bus:                  16-bit ISA

  Size:                      Half-length, full-height card

  Hard drive supported:      Two IDE(AT) drives

  Floppy drives supported:   Two 360KB, 720KB, 1.2MB, or 1.44MB drives

[Image]

                        CONNECTIONS

                Function                      Location

  40-pin primary IDE(AT) connector               J1

  34-pin cable connector - floppy drive          J2

  9-pin serial port 1 - external                 P1

  25-pin parallel port - external                P2

  4-pin connector - drive active LED            JP1

  10-pin serial port 2 - internal               JP7

                        USER CONFIGURABLE SETTINGS

              Function                   Location            Setting

  »   Parallel port is LPT1                 JP2             pins 1 & 2
                                                              closed

      Parallel port is LPT2                 JP2             pins 2 & 3
                                                              closed

  »   Serial Port 2 is COM2                 JP3             pins 2 & 3
                                                              closed

      Serial Port 2 is COM4                 JP3             pins 1 & 2
                                                              closed

  »   Serial Port 1 is COM1                 JP4             pins 2 & 3
                                                              closed

      Serial Port 1 is COM3                 JP4             pins 1 & 2
                                                              closed

  »   IOCHRDY signal disabled               JP5                open

      IOCHRDY signal enabled                JP5               closed

  »   Floppy drive interface                JP6               closed
      enabled

      Floppy drive interface                JP6                open
      disabled

                   USER CONFIGURABLE SETTINGS CONTINUED

             Function                   Location             Setting

  »   Parallel port IRQ 7 select           JP8          pins 1 & 2 closed

      Parallel port IRQ 5 select           JP8          pins 2 & 3 closed

  »   Serial Port 1 IRQ4 select            JP9          pins 1 & 2 closed

      Serial Port 1 IRQ5 select            JP9          pins 2 & 3 closed

  »   Serial Port 2 IRQ3 select           JP10          pins 1 & 2 closed

      Serial Port 2 IRQ5 select           JP10          pins 2 & 3 closed