AUVA COMPUTER, INC. HFDC-II Data bus: 16-bit ISA Size: Three-quarter length, full-height card Hard drive supported: Two MFM ST-506/412 drives Floppy drives supported: Two 360KB, 720KB, 1.2MB, or 1.44MB drives [Image] CONNECTIONS Function Location 4-pin connector - drive active LED J1 20-pin data cable connector - drive 1 J2 20-pin data cable connector - drive 0 J3 34-pin control cable connector - hard drive J4 34-pin control cable connector - floppy drive J5 USER CONFIGURABLE SETTINGS Function Location Setting LED always "on" when system W1/1 open on LED "on" only when drive is W1/1 closed being accessed » Four byte ECC enabled W1/2 open Reserved - do not use W1/2 closed Cache enabled W1/3 open Cache disabled W1/3 closed Interleave ratio is 1:1 W1/4 open Maximum interleave ratio is W1/4 closed 1:3 Floppy drive primary address W2 open is 3F2-3F7h Floppy drive secondary W2 closed address is 372-377h Note: Close W1/4 when using disks formatted under the WD1003-WAH controller. USER CONFIGURABLE SETTINGS CONTINUED Function Location Setting Hard drive primary address is W3 open 1F0-1F7h Hard drive secondary address W3 closed is 170-177h Floppy drive single speed W4 open enabled Floppy drive dual speed W4 closed enabled