LARK ASSOCIATES, INC. LRK-330/331 Data bus: 16-bit ISA Size: Three-quarter length, full-height card Hard drive supported: Two ESDI drives Floppy drives supported: Two 360KB, 720KB, 1.2MB, or 1.44MB drives [Image] CONNECTIONS Function Location 34-pin cable connector - floppy drive J1 20-pin data cable connector- drive 1 J3 20-pin data cable connector- drive 0 J4 34-pin control cable connector-hard drive J5 4-pin connector - drive active LED J6 USER CONFIGURABLE SETTINGS Function Location Setting » Primary hard drive address is W1 open 1F0h-1F7h Primary floppy drive address is 370h-3F7h » Secondary hard drive address is W1 closed 170h-177h Secondary floppy drive address is 370h-377h » Floppy drive is single speed W2 open Floppy drive is dual speed W2 closed » Interrupt delay disabled W3 open Interrupt delay enabled W3 closed USER CONFIGURABLE SETTINGS (CONTINUED) Function Location Setting » Factory configured - do not W4 N/A alter » IDE(AT) IRQ 14 select W9 closed IDE(AT) IRQ 15 select W10 closed » Floppy drive interface enabled W11 open Floppy drive interface disabled W11 closed Note: W12 is unidentified BIOS ADDRESS SELECTION Address W5 W6 W7 W8 » C800h closed open open open CC00h open closed open open D000h open open closed open D400h open open open closed Disabled open open open open