PLUS DEVELOPMENT CORPORATION

IMPULSE 150A

  Data bus:                  16-bit ISA

  Size:                      Half-length, full-height card

  Hard drive supported:      Two IDE(AT) drives

  Floppy drives supported:   Two 360KB, 720KB, 1.2MB, or 1.44MB drives

[Image]

                        CONNECTIONS

                Function                      Location

  34-pin cable connector - floppy drive          J1

  40-pin IDE(AT) connector                       J2

  4-pin connector - drive active LED            JP9

                        USER CONFIGURABLE SETTINGS

              Function                    Location           Setting

  »   Factory configured - do not           JP1                open
      alter

  »   Factory configured - do not         JP2/1-3              open
      alter

  »   Factory configured - do not         JP3/1-3              open
      alter

  »   Factory configured - do not           JP4                open
      alter

  »   Factory configured - do not           JP5                open
      alter

  »   Polled BIOS                      JP6/pins 2 & 3         closed

      BIOS is interrupt driven         JP6/pins 1 & 2         closed

  »   Factory configured - do not           JP7                open
      alter

  »   Floppy drive interface                JP8               closed
      enabled

      Floppy drive interface                JP8                open
      disabled

  »   Factory configured - do not           JP10              closed
      alter