DATA TECHNOLOGY CORPORATION

DTC2132D

  Data bus:                  32-bit PCI

  Size:                      Half-length, half-height card

  Hard drive supported:      Four IDE(AT) or EIDE interface drives

  Floppy drives supported:   None

[Image]

                                CONNECTIONS

                    Function                             Location

  10-pin DTC-1415 ISA B Interrupt adapter                   J1
  connector

  4-pin connector - drive active LED                        J2

  40-pin connector - primary IDE(AT) interface              J3

  40-pin connector - secondary IDE(AT)                      J4
  interface

  Note: Connector J1 is intended for use in systems that do not support
  redirected PCI interrupts.

                        USER CONFIGURABLE SETTINGS

               Function                     Location          Setting

  »   Primary port INTA redirect to      W1/pins 1 & 3         closed
      IRQ14

      Primary port INTB redirect to      W1/pins 2 & 4         closed
      IRQ14

      Primary port INTC redirect to      W1/pins 3 & 5         closed
      IRQ14

      Primary port INTD redirect to      W1/pins 4 & 6         closed
      IRQ14

      Secondary port INTA redirect to    W2/pins 1 & 3         closed
      IRQ15, IRQ12 or IRQ11

      Secondary port INTB redirect to    W2/pins 2 & 4         closed
      IRQ15, IRQ12 or IRQ11

      Secondary port INTC redirect to    W2/pins 3 & 5         closed
      IRQ15, IRQ12 or IRQ11

      Secondary port INTD redirect to    W2/pins 4 & 6         closed
      IRQ15, IRQ12 or IRQ11

  »   Fixed IDE address at power-up            W3              closed
      (1F0-1F7h)

      Relocatable IDE address at               W3               open
      power-up

  »   IDE decode state disabled after          W4              closed
      reset

      IDE decode state enabled after           W4               open
      reset