ALPHA DESIGN AD-102V Data bus: 16-bit ISA Size: Three-quarter length, Full-height card Hard drive supported: Two IDE(AT) interface drives Floppy drives supported: 360KB, 720KB, 1.2MB, 1.44MB [Image] CONNECTIONS Function Location 34-pin control cable connector - floppy drive J1 20-pin data cable connector - drive 1 J3 20-pin data cable connector - drive 0 J4 34-pin control cable connector - hard drive J5 4-pin connector - drive active LED J6 USER CONFIGURABLE SETTINGS Function Location Setting » Controller is incompatible with W2 open WD1003-WA2 Controller is compatible with W2 closed WD1003-WA2 » Hard drives in latched mode W3 open Hard drives in non-latched mode W3 closed » Caching enabled W4 open Caching disabled W4 closed USER CONFIGURABLE SETTINGS(CONTINUED) Function Location Setting » 4-byte ECC enabled W5 open 7-byte ECC enabled W5 closed » Hard drive primary address W6 open select Hard drive alternate address W6 closed select » Floppy drive interface primary W7 open address select Floppy drive interface W7 closed alternate address select » Factory configured - do not W8 N/A alter » Single speed floppy drive W17 open supported Dual speed floppy drive W17 closed supported » Mounting bracket not grounded W18 open Mounting bracket grounded W18 closed