UNIDENTIFIED

GW-106V/GW-106V1

  Data bus:                  16-bit ISA

  Size:                      Three-quarter length, full-height card

  Hard drive supported:      Two ST506/412 drives

  Floppy drives supported:   360KB, 720KB, 1.2MB, 1.44MB

[Image]

                               CONNECTIONS

                    Function                             Location

  34-pin control cable connector - floppy drive             J1

  20-pin data cable connector - drive 1                     J3

  20-pin data cable connector - drive 0                     J4

  34-pin control cable connector - hard drive               J5

  4-pin connector - drive active LED                       JP1

                        USER CONFIGURABLE SETTINGS

                Function                    Location          Setting

  »   Latched hard drive mode enabled         JP2/A             open

      Non-latched hard rive mode              JP2/A            closed
      enabled

  »   Four byte ECC enabled                   JP2/B             open

      Reserved                                JP2/B            closed

  »   Caching enabled                         JP2/C             open

      Caching disabled                        JP2/C            closed

  »   Factory configured - do not             JP2/D             N/A
      alter

  »   Floppy drive interface primary           JP3              open
      address select

      Floppy drive interface alternate         JP3             closed
      address select

                   USER CONFIGURABLE SETTINGS(CONTINUED)

                Function                    Location          Setting

  »   Hard drive interface primary             JP4              open
      address select

      Hard drive interface alternate           JP4             closed
      address select

  »   Bracket ground disabled                  JP5              open

      Bracket ground enabled                   JP5             closed

  »   Floppy drive interface single            JP6              open
      speed enabled

      Floppy drive interface dual              JP6             closed
      speed enabled

  Note: The location of jumper JP5 is unspecified in manufacturer
  documentation.