DATA TECHNOLOGY CORPORATION

DTC5180C REV. G

  Data bus:                  16-bit, ISA

  Size:                      Half-length, full-height card

  Hard drive supported:      Two MFM ST506/412 drives

  Floppy drives supported:   None

[Image]

                            CONNECTIONS

                   Function                          Location

  34-pin control cable connector - hard drive           J1

  20-pin data cable connector-drive 0                   J2

  20-pin data cable connector-drive 1                   J3

  4-pin connector-Drive active LED                      J4

                        USER CONFIGURABLE SETTINGS

              Function                    Location            Setting

  »   Floppy drive change not                W1                open
      driven

      Floppy drive change signal             W1               closed
      driven low

  »   Hard drive port address is           W4 & W5             open
      3F6, 3F7, 1F0-1F7h

      Hard drive port address is           W4 & W5            closed
      376, 377, 170-177h

                HARDWARE/FIRMWARE DRIVE SELECT MODE ENABLE

     Function       W2 & W3/jumper 1    W2 & W3/jumper 2         W6

  Hardware mode          closed               open             closed

  Firmware mode           open               closed             open