BUSLOGIC, INC. BT-445S Data bus: 32-bit, VL-bus Size: Three/quarter-length, full-height card Hard drive supported: Up to seven SCSI devices Floppy drives Two 360KB, 720KB, 1.2MB, or 1.44MB drives supported: [Image] CONNECTIONS Function Location 4-pin connector-Drive active LED J1 34-pin control cable connector-floppy drive J2 50-pin SCSI connector - internal J3 50-pin SCSI connector - external J4 SCSI ID ID SW1/switch 1 SW1/switch 2 SW1/switch 3 0 off off off 1 on off off 2 off on off 3 on on off 4 off off on 5 on off on 6 off on on » 7 on on on USER CONFIGURABLE SETTINGS Function Location Setting » SCSI parity check enabled SW1/switch 4 on SCSI parity check disabled SW1/switch 4 off » Hard drive capacity > 1GB disabled SW1/switch 5 on Hard drive capacity > 1GB enabled SW1/switch 5 off » SCSI synchronous negotiation disabled SW1/switch 6 on SCSI synchronous negotiation enabled SW1/switch 6 off » SCSI 5MB/sec data transfer rate enabled SW1/switch 7 on SCSI 10MB/sec data transfer rate enabled SW1/switch 7 off » Floppy drive port address is 3F0-3F7h W14 open Floppy drive port address is 370-377h W14 closed » Floppy drive enabled W15 & W16 closed Floppy drive disabled W15 & W16 open VL-BUS CLOCK SPEED CONFIGURATION Clock Speed SW1/switch 8 SW1/switch 9 SW1/switch 10 20MHz on on off 25MHz off on off » 33 or 40MHz on on on 50MHz on off on 50i MHz off on off 66i MHz on on on I/O PORT ADDRESS Address SW2/switch 1 SW2/switch 2 SW2/switch 3 130-133h on off on 134-137h on off off 230-233h off on on 234-237h off on off » 330-333h on on on 334-337h on on off BIOS ADDRESS Address SW2/switch 4 SW2/switch 5 » DC000h on on C8000h off off D8000h off on Disabled on off HOST INTERRUPT REQUEST IRQ SW2/switch 6 SW2/switch 7 SW2/switch 8 9 on off on 10 off on on » 11 on on on 12 off off on 14 on on off 15 off on off HOST INTERRUPT CHANNEL Channel Jumper W3 Jumper W4 Jumper W5 Jumper W6 Jumper W7 Jumper W8 9 open open open open open closed 10 open open open open closed open 11 open open open closed open open » 12 open open closed open open open 14 open closed open open open open 15 closed open open open open open MISCELLANEOUS TECHNICAL NOTES SW2/switch 9 and SW2/switch 10 are factory configured - do not alter