EVEREX SYSTEMS, INC.

EV-368

Data Bus:                16-bit ISA
Size:                    Half-length, Full-height card
Hard drives supported:   Two IDE (AT) Interface drives
Floppy drives supported: Two 360KB, 720KB, 1.2MB, or 1.44MB drives

[Image]

                                CONNECTIONS

               Function                             Location

  40-pin IDE (AT) Interface connector                 CN1

  2-pin connector - Drive active LED                   J2

  34-pin control cable connector -                    CN2
  floppy drive

  15-pin game port - internal                         CN3

  10-pin serial port (COM1/3) -                       CN4
  internal

  10-pin serial port (COM2/4) -                       CN5
  internal

  25-pin parallel port (LPT2/3)                       CN6
  external

                        USER CONFIGURABLE SETTINGS

              Function                   Location            Setting

  »   I/O Channel Ready signal              J1               Closed
      enabled

      I/O Channel Ready signal              J1                Open
      disabled

  »   Serial port 2 (CN5) is set to         JP1         Pins 1 & 2 closed
      COM2

      Serial port 2 (CN5) is set to         JP1         Pins 2 & 3 closed
      COM4

  »   Serial port 2 (CN5) enabled           JP2         Pins 1 & 2 closed

      Serial port 2 (CN5) disabled          JP2         Pins 2 & 3 closed

  »   Game port (CN3) enabled               JP3         Pins 1 & 2 closed

      Game port (CN3) disabled              JP3         Pins 2 & 3 closed

  »   Serial port 1 (CN4) is set to         JP4         Pins 1 & 2 closed
      COM1

      Serial port 1 (CN4) is set to         JP4         Pins 2 & 3 closed
      COM4

  »   Printer port is set to LPT2           JP5         Pins 1 & 2 closed

      Printer port is set to LPT3           JP5         Pins 2 & 3 closed

  »   Serial port 1 (CN4) enabled           JP6         Pins 1 & 2 closed

      Serial port 1 (CN4) disabled          JP6         Pins 2 & 3 closed

  »   Floppy drive enabled                  JP7         Pins 1 & 2 closed

      Floppy drive disabled                 JP7         Pins 2 & 3 closed

  »   Hard drive controllers exist          JP8         Pins 1 & 2 closed

      Hard drive controllers do not         JP8         Pins 2 & 3 closed
      exist

  »   Hard drive enabled                    JP9         Pins 1 & 2 closed

      Hard drive disabled                   JP9         Pins 2 & 3 closed

  »   Printer port enabled                 JP10         Pins 1 & 2 closed

      Printer port disabled                JP10         Pins 2 & 3 closed