NCL AMERICA NCL 525 Data bus: 16-bit, ISA Size: Three/quarter-length, full-height card Hard drive supported: Four IDE(AT) Interface drives Floppy drives Two 360KB, 720KB, 1.2MB, or 1.44MB drives supported: [Image] CONNECTIONS Function Location 40-pin IDE(AT) Interface connector - IDE-0 J5 40-pin IDE(AT) Interface connector - IDE-1 J6 34-pin control cable connector - floppy drive J3 4-pin connector - Drive active LED J4 BIOS ADDRESS Address Jumper JP8 Jumper JP8A » C800h open open CC00h closed open D800h open closed DC00h closed closed USER CONFIGURABLE SETTINGS Function Location Setting » DMA Request channel is DRQ2 JP1 Pins 1 & 2 closed DMA Request channel is DRQ3 JP1 Pins 2 & 3 closed » DMA Acknowledge channel is JP2 Pins 1 & 2 DACK2 closed DMA Acknowledge channel is JP2 Pins 2 & 3 DACK3 closed » IDE-0 Hard Drive interrupt is JP3 Pins 1 & 2 IRQ14 closed IDE-0 Hard Drive interrupt is JP3 Pins 2 & 3 IRQ11 closed » IDE-1 Hard Drive interrupt is JP4 Pins 1 & 2 IRQ15 closed IDE-1 Hard Drive interrupt is JP4 Pins 2 & 3 IRQ12 closed » IDE-0 IRQ Buffer mode disabled JP5 Pins 1 & 2 closed IDE-0 IRQ Buffer mode enabled JP5 Pins 2 & 3 closed » IDE-0 I/O Channel Ready JP6 open disabled IDE-0 I/O Channel Ready JP6 closed enabled » IDE-1 I/O Channel Ready JP7 open disabled IDE-1 I/O Channel Ready JP7 closed enabled » Floppy drive interrupt is IRQ6 JP9 Pins 1 & 2 closed Floppy drive interrupt is JP9 Pins 2 & 3 IRQ10 closed » Floppy drive port address is JP10 closed 3F2-3F7h Floppy drive port address is JP10 open 372-377h » IDE-0 normal operation mode JP11 open enabled IDE-0 diagnostic mode enabled JP11 closed » IDE-1 normal operation mode JP12 open enabled IDE-1 diagnostic mode enabled JP12 closed » IDE-1 IRQ Buffer mode disabled JP13 Pins 1 & 2 closed IDE-1 IRQ Buffer mode enabled JP13 Pins 2 & 3 closed » Floppy drive enabled JP14 open Floppy drive disabled JP14 closed