SILICON VALLEY COMPUTER, INC. ADP65 Data bus: 16-bit, ISA Size: Half-length, full-height card Hard drives supported: Up to four IDE (AT) Interface drives or up to two IDE tape drives Floppy drives supported: Up to four 360KB, 720KB, 1.2MB, or 1.44MB [Image] CONNECTIONS Function Location 34-pin control cable connector-floppy drives 0 P1 and 1 34-pin control cable connector-floppy drives 2 P2 and 3 4-pin connector-Drive active LED for P5 P3 4-pin connector-Drive active LED for P6 P4 40-pin IDE (AT) Interface connector (Drives 0 and P5 1) 40-pin IDE (AT) Interface connector (Drives 2 and P6 3) Note: Connector P5 only supports hard drives, any tape drives must be chained from P6. USER CONFIGURABLE SETTINGS Function Location Setting » Reserved for ROM Size, must SW1/switch 7 off be left as shipped » Floppy drive enabled SW1/switch 8 on Floppy drive disabled SW1/switch 8 off » IRQ15 enabled on CN6 E9 closed IRQ15 disabled E9 open » IRQ14 enabled on CN5 E10 closed IRQ14 disabled E10 open PORT ADDRESS CONFIGURATION HD Port 1 HD Port 2 SW1/switch 4 SW1/switch 5 SW1/switch 6 (CN5) (CN6) Disabled Disabled off off off 1F0-1F7h Disabled off on off 170-177h Disabled off on on 1F0-1F7h 170-177h on on off BIOS ADDRESS Address SW1/switch 1 SW1/switch 2 SW1/switch 3 Disabled off off off » C800h / 8K on off off CA00h / 8K off on off C800h / 16K on on off CC00h / 8K on off on CE00h / 8K off on on CC00h / 16K on on on