PERCEPTIVE SOLUTIONS, INC.

WINSTOR, QUICKCACHE

Data bus: 16-bit, ISA

Size: Full-length, full-height card

Hard Drives Supported: Four AT Interface (IDE) drives

Floppy Drives Supported: Two or Four 360KB, 720KB, 1.2MB, or 1.44MB drives

[Image]

                                CONNECTIONS

                      Functiion                             Location

  4-pin connector-drive active LED                             J1

  40-pin control cable connector-hard drive 1&2                J3

  40-pin control cable connector-hard drive 3&4                J4

  34-pin control cable connector-floppy drive                  J5

  34-pin control cable connector-floppy drive                  J6
  (optional)

  50-pin receptacle-Hardware Data Compression Module           J7
  (winSTOR only)

                        USER CONFIGURABLE SETTINGS

              Function                     Location           Setting

  »   Floppy drive enabled               SW1/switch 1           off

      Floppy drive disabled              SW1/switch 1            on

  »   Single-speed floppy supported      SW1switch 2            off

      Dual-speed floppy supported        SW1/switch 2            on

  »   Factory configured - do not        SW1/switch 3           off
      alter

  »   Factory configured - do not        SW1/switch 4           off
      alter

                       MISCELLANEOUS TECHNICAL NOTES

   Both the winSTOR and the quickCACHE may use 256KB, 1MB or 4MB x8 or x9
     SIMM's (100ns or faster). A minimum of 512K cache is required for
  operation. The winSTOR has 512K on-board and does not require SIMM's to
                                 operate.