NCL AMERICA NCL 538, NCL 539 Data bus: 16-bit, ISA Size: Half-length, full-height card Hard drives supported: Two AT Interface (IDE) drives Floppy drives supported: NCL 538: Two 360KB, 720KB, 1.2MB, or 1.44MB NCL 539: None Maximum heads/cyl.: 16 heads and 2048 cylinders [Image] CONNECTIONS Function Location 34-pin control cable connector-floppy drive (NCL CN1 538 only) 40-pin AT Interface (IDE) control cable CN2 connector-internal 4-pin connector-drive active LED CN3 5-pin connector-DC power JP11 USER CONFIGURABLE SETTINGS Function Location Setting » Floppy drive port address is JP1 pins 1 & 2 3F2-3F7h (538 only) closed Floppy drive port address is JP1 pins 2 & 3 372-377h (538 only) closed » BIOS address is C800h JP2 pins 1 & 2 closed BIOS address is CC00h JP2 pins 2 & 3 closed » Floppy Drive Interrupt is IRQ6 JP3 pins 1 & 2 (538 only) closed Floppy Drive Interrupt is IRQ10 JP3 pins 2 & 3 (538 only) closed » Floppy Drive DMA Acknowledge is JP4 pins 1 & 2 DACK2 (538 only) closed Floppy Drive DMA Acknowledge is JP4 pins 2 & 3 DACK3 (538 only) closed » IRQ Non-buffered JP5 pins 1 & 2 closed IRQ buffered JP5 pins 2 & 3 closed » Floppy Drive DMA Request is DRQ2 JP6 pins 1 & 2 (538 only) closed Floppy Drive DMA Request is DRQ3 JP6 pins 2 & 3 (538 only) closed » Hard Drive Interrupt is IRQ14 JP7 pins 1 & 2 closed Hard Drive Interrupt is IRQ15 JP7 pins 2 & 3 closed » Zero wait state enabled JP8 open Zero wait state disabled JP8 closed » BIOS enabled JP9 closed BIOS disabled JP9 open » Hard drive port address is JP10 open 1F0-1F7h Hard drive port address is JP10 closed 170-177h » Normal operation JP11 open Self-diagnostic mode JP11 closed