DATA TECHNOLOGY CORPORATION DTC6290-24, DTC6290E, DTC6290SE Data bus: 32-bit, EISA Size: Full-length,full-height card Hard drives supported: Four 10-15Mbit/sec ESDI drives on the DTC6290E Four 10-24Mbit/sec ESDI drives on the DTC6290-24 Four 10-15Mbit/sec ESDI drives and up to seven SCSI devices on the DTC6290SE Floppy drives supported: Three 360KB, 720KB, 1.2MB, or 1.44MB Sector interleave: 1:1 [Image] CONNECTIONS Function Location 34-pin control cable connector-hard drive J1 20-pin data cable connector-drive 0 J2 20-pin data cable connector-drive 1 J3 34-pin data cable connector-floppy drive J3A 20-pin data cable connector-drive 2 J4 20-pin data cable connector-drive 3 J5 4-pin connector-drive active LED J6 50-pin SCSI connector-external (DTC6290SE only) J7 50-pin SCSI connector-internal (DTC6290SE only) J8 USER CONFIGURABLE SETTINGS Function Location Setting » Factory cofigured - do not SW1/switch 1 off alter » Factory cofigured - do not SW1/switch 2 off alter » Factory cofigured - do not SW1/switch 3 off alter » "Bad sector" list on cyl N-1 SW1/switch 4 on and cyl N-9 "Bad sector" list on cyl N-1 SW1/switch 4 off (N = # of Cyl.) » Factory cofigured - do not SW1/switch 5 off alter » Floppy drive enabled SW1/switch 6 off Floppy drive disabled SW1/switch 6 on » HD, FD and EISA register are SW1/switch 7 off accessible EISA registers are accessible SW1/switch 7 on only » Port addresses are 1F0-1F7h SW1/switch 8 off and 3F2-3F7h Port addresses are 170-177h SW1/switch 8 on and 372-377h