 |
This task explains the isogen endstyle mapping design rule. | |
|
The isogen endstyle
mapping design rule included with this application is used when you are
creating a 2-D isometric drawing from a 3-D document. The process uses
third party software called Alias I-Run. You use this table to enter the
different values for the attribute endstyle in this application, and their
equivalent names in Alias I-Run. For instance, the endstyle BUTT WELD is
called BW in Alias I-Run.
This is a general design rule and the associated table is located in the directory ...\intel_a\Startup\EquipmentAndSystems\XXXXX\DesignRules, where XXXXX is the application name, such as Piping. |
|
 |
1. | The image below shows the
endstyle mapping design table for the Piping Design product.
The column EndStyle lists the Piping Design endstyle values while the column ISOgenEndStyle lists the equivalent Alias I-Run endstyle values. |
|
|
||
