ISO Attribute Mapping Rule

atarget.gif (1372 bytes) This task explains the isogen attribute mapping design rule.

The isogen attribute mapping design rule included with this application is used when you are creating a 2-D isometric drawing from a 3-D document. The process uses third party software called Alias I-Run. You use this table to enter the attributes in this application, and their equivalent names in Alias. For instance, the attribute TracingSpecification is called TRACING-SPEC in Alias I-Run.

This is a general design rule and the associated table is located in the directory ...\intel_a\Startup\EquipmentAndSystems\XXXXX\DesignRules, where XXXXX is the application name, such as Piping.

ascenari.gif (1364 bytes) 1. The image below shows the attribute mapping design table for the Piping Design product.

The column AttributeName lists the Piping Design attribute while the column ISOgenAttributeName lists the equivalent Alias I-Run attribute.

aendtask.gif (1477 bytes)