Defining the Sheet Metal Parameters

This task shows you how to configure the Generative Sheetmetal parameters.

1. Click Sheet Metal Parameters .

   The Sheet Metal Parameters dialog box is displayed.

2. Enter 1mm in the Thickness field.

3. Enter 5mm in the Default Bend Radius field.

4. Select the Bend Extremities tab.

5. Select Tangent in the Bend Extremities combo list.

   An alternative is to select the bend type in the graphical combo list.

6. Click OK to validate the parameters and close the dialog box.

   The Sheet Metal Parameters feature is added in the specification tree.

The third tab is not used in this scenario.