This task shows you how to browse a V4 NC Lathe Machining Operation in the NC Manufacturing Review workbench. | ||||||
1. | In the specification tree containing a Part Operation
originating from V4, double click the machining operation to be browsed
(see Browse a V4 NC Lathe Model).
The machining operation browse panel appears. The properties are organized in tab pages as follows:
|
|||||
Parameters of the machining strategy page
The set of machining options of the NC Lathe machining operation are displayed along with their values. |
||||||
Geometry to be machined
The set of possible geometry entity types are listed for the operation. Entity types that are not referenced by the selected operation are dimmed. Entity types that are referenced by the selected operation can be highlighted by clicking the corresponding checkbox. Only geometry with SHOW status in the V4 model is considered to be linked to the operation. |
||||||
Tool used in the operation
The displayed tool corresponds to the previous Tool Change operation of the NC Lathe set. If a Detailed tool was used no information is displayed. |
||||||
Feedrates
The set of feedrates and spindle speeds of the NC Lathe machining operation are displayed along with their values. |
||||||
2. | Just click Cancel to close the machining operation panel. | |||||
|