What's New?

Enhanced Functionalities

Improved Milling Feature Recognition

When running Feature Recognition, the milling areas (with not planar top element) are now taken into account for feature creation (Prismatic Machining Area). Previously, conditional checking was done on top and bottom face. These conditions were replaced by stringent condition checking on bottom face only, whereas conditions are not applied on top face. The top face can be any surface, it does not need to be planar which is parallel to bottom face.

Feature recognition will now provide a Prismatic Machining Area corresponding to a Complex Pocket. The boundary will be defined by a hard boundary only. An imaginary contour at the intersection of Hole and Slot, is automatically defined to close the hard contour.