This task shows you how to insert a Profile Finish Turning operation in the program. | ||
1. | Select the Profile Finish Turning icon . The Profile Finish Turning dialog box appears directly at the Geometry page . | |
2. | Select the red part in the sensitive icon then select the part profile. | |
3. | Select the Strategy tab page and set the Leading Safety Angle to 0 degrees. | |
4. | Click Replay to replay the operation as
described previously.
Click OK to exit the replay mode and return to the Profile Finish Turning dialog box. |
|
5. | Click OK to create the operation in the program. | |
|