This task shows you how to
reposition components in a network.
If you reposition one component
that is in a duct line the line will stretch to accommodate the move.
Similarly, you can also reposition several components at the same time. To
do this you select them, in which case they are considered to be part of
one set that can be manipulated.
1.
Select the components that you want
to reposition. In the image below, the pump and valve outlined in red have
been selected. The line between them also gets included in the set.
2.
Click on any of the selected
components, or the line, and drag to reposition where you want it. All the
selected components will move and the line will stretch to maintain the
connection with the rest of the diagram. In the image below the selected
components have been moved higher and away from the tank.