|
There are a few things you need to know before
you start migrating Version 4 Functional Dimensioning and Tolerancing data to
Version 5:
- Migration is performed using a Copy-Paste operation. You should paste
the Version 4 annotation set at the level of the product containing the
geometry.
- Version 4 tolerancing data is migrated for parts only, not for
assemblies.
- To migrate Version 4 Functional Dimensioning and Tolerancing data to
Version 5, a Version 5 Functional Tolerancing and Annotation license is
required.
- Not all Version 4 data can be migrated to Version 5, and sometimes,
migrated data can be invalid.
- If an annotation set already exists in Version 5, Version 4 data
will be pasted to this existing annotation set. In this case, make sure
that the parent standard is the same in Version 4 as in Version 5,
otherwise the copy will not be performed.
- If there is no existing annotation set in Version 5, a new annotation
set will be created. In this case, the Version 4 standard will be
used.
- In the case of several Version 4 annotation sets within a
Version 4 model, you will either need to merge FDandT data within a
single Version 5 annotation set, or split the Version 4 model in
several Version 4 models, containing each a single annotation set.
- Version 4 Functional Dimensioning and Tolerancing windows are
migrated as Version 5 captures.
|