The Templates tab contains the following categories of options:
This option specifies the minimum height for plate forming templates.
By default, this option is set to 2000 mm.
This option defines the default amount of stock to add to the shape before cutting and bending.
By default, this option is set to 55 mm.
This option specifies to which end or ends of the shape the Over Length is added to.
By default, this option is set to None.
This option specifies whether or not inverse bending curves are to be generated.
By default, this option is enabled.
This option specifies a clearance zone in which inverse bending curves will not be generated.
By default, this option is set to 5mm.
This option specifies the minimum distance between the ends of inverse bending curves.
By default, this option is set to 450mm.
This option defines the work lines spaced along the neutral axis that are used to extract inverse bending curve data.
By default, this option is set to 250mm.
This option specifies whether or not templates are to be generated.
By default, this option is enabled.
This option determines whether to generate more than one template. If the length along the neutral axis is greater than the maximum length entered, more than one template is generated.
By default, this option is set to 2000mm.